Burning resin on charcoal is one of the oldest ways to release scent. The method is simple. A small glowing disc, a heatproof dish and a few tears of resin are enough. This guide covers what the charcoal does, where the practice comes from, how to light it, and how to choose what you need.
What the charcoal does
Loose resin does not burn like a stick of incense. It needs steady, gentle heat from below. Charcoal supplies it.
Our self-lighting charcoal tablets, three rolls to a pack, are made for this purpose. Each round disc carries a small saltpetre charge in the binder. It lets the disc ignite from a single flame and hold its temperature for about forty-five to sixty minutes. They are A-grade: low smoke from the charcoal itself, and reliable self-ignition.
The heat matters. A lit tablet reaches roughly 600 to 900 degrees Celsius. That is the range needed to vaporise the volatile aromatic compounds in frankincense, copal, myrrh and other resin tears. The resin is then warmed on the disc and gives off its scent.
A short history
Resins have been gathered and burned for a very long time. Frankincense and myrrh are old materials of trade and ritual across Arabia, the Mediterranean and beyond. Charcoal discs are the format used across European, Middle Eastern and South Asian resin-incense traditions. Different places, one method.
The practice has lasted because it is direct. One ember, one piece of resin, one dish.
How to burn resin on charcoal
Set up before you light anything. Work on a stable, heatproof surface, away from fabric and paper.
- Prepare the burner. Use a dish made for heat. A layer of sand or ash in the base helps to hold the disc and spread the warmth.
- Light the edge. Hold the tablet with tongs. Bring a flame to the edge. It catches, then glows progressively across its surface within 30 to 45 seconds.
- Let it ash over. Place the disc in the burner. Wait until a thin grey ash covers the surface. This is the moment to add resin.
- Add a small piece. Start with one or two tears. You can always add more. Heaping resin on the disc smothers it.
- Finish safely. Let the disc burn out fully and cool before you empty the dish. Never leave a lit disc unattended.
Keep the room ventilated. Handle the disc only with tongs.
The scent
The scent depends on the resin, not the charcoal. A good tablet stays out of the way. Frankincense, copal and myrrh each behave differently once warmed. Some are bright and some are deeper. The best way to learn them is to burn them side by side.
The Resin Discovery Kit is built for this. It holds eight 15g samples, 120g in all, from Omani Hojari frankincense to Peruvian palo santo powder. They span five countries across four continents. Each 15g portion is enough for several charcoal sessions per material.
How to choose
Choose the charcoal first. Look for tablets that light from a single flame and burn low in smoke. Check the burn time, so you know how long a session will run.
- Everyday use. A single roll of charcoal tablets suits an occasional burner.
- Regular use. The full box holds around 100 tablets. That is enough for several months of weekly use, or several weeks of daily use.
Then choose the burner. The wooden incense burner with a floral design has a removable stainless steel base that holds the disc. The steel absorbs the heat and isolates it from the wooden body, so the charcoal never sits against the wood. It comes in three sizes. It suits resins, palo santo powder and incense cones on self-igniting charcoal.
Finally, choose the resin. If you are new to it, begin with a few small samples. Burn one at a time and note the differences.
You can see the range in person at our boutique in Warehouse 23, Alserkal Avenue, Dubai. We also deliver across the UAE.
